Thread: hardware notes class 20th
- Join Date
- Feb 2010
- Rep Power
hardware notes class 20th
Chapter 18. Overclocking
The Pentium II was subjected to a lot of overclocking. It was found that many of IntelÃ¢â‚¬â„¢s CPUÃ¢â‚¬â„¢s could be clocked at a higher factor than they were designed for.
If you had a 233 MHz Pentium II, you could set up the motherboard to, for example, run at 4.5 x 66 MHz, so that the processor ran at 300 MHz. I tried it myself for a while, it worked well. At a factor of 5 it didnÃ¢â‚¬â„¢t work, but at factor of 4.5 it functioned superbly.
133 MHz x 2
166 MHz x 2
100 MHz x 4
133 MHz x 4
200 MHz x 4
Overclocking the system bus
Another method of overclocking was to turn up the system bus clock frequency. In the early versions of the Pentium II, the system bus was at 66 MHz, which suited the type of RAM used at that time.
You could increase the bus speed, for example to 68 or 75 MHz, depending on how fast your RAM was. This type of tuning makes both the CPU and RAM faster, since it is the actual system clock speed which is increased.
The disadvantage is that the system clock in these motherboard architectures also controls the I/O bus, which runs synchronously with the system bus. PCI bus devices (which we will come to in a later chapter) cannot handle being overclocked very much; otherwise faults can occur, for example in reading from the hard disk.
Overclocking typically requires a higher voltage for the CPU, and most motherboards can be set up to supply this:
Figur 123. Setting the CPU voltage using the motherboardÃ¢â‚¬â„¢s Setup program. Many still use the same kind of overclocking on the Athlon XP and Pentium 4. The system clock has to be able to be adjusted in increments, which it can on many motherboards.
Figur 124. A gigantic cooler with two fans and pure silver contact surfaces. Silverado, a German product which is used for overclocking CPUÃ¢â‚¬â„¢s. Example using the Pentium 4
A Pentium 4 processor is designed for a system clock of 200 MHz. If you can have a 3200 MHz model with a 200 MHz system bus, it can theoretically be clocked up to 4000 MHz by turning up the system clock. However, the processor needs a very powerful cooling system to operate at the increased frequencies:
Fig. 125. Overclocking a Pentium 4 processor.
The manufacturers, Intel and AMD, donÃ¢â‚¬â„¢t like people overclocking their CPUÃ¢â‚¬â„¢s. They have sometimes attempted to prevent this by building a lock into the processors, so that the processor can only work at a specific clock frequency. In other cases the CPUÃ¢â‚¬â„¢s can be overclocked. In any case, you shouldnÃ¢â‚¬â„¢t expect your warranty to apply if you play around with overclocking.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By $$$lover in forum Computer HardwareReplies: 2Last Post: 12-21-2010, 12:17 AM
By $$$lover in forum Computer HardwareReplies: 3Last Post: 12-19-2010, 11:17 PM
By $$$lover in forum Computer HardwareReplies: 1Last Post: 03-01-2010, 10:45 PM
By $$$lover in forum Computer HardwareReplies: 1Last Post: 03-01-2010, 10:44 PM
By $$$lover in forum Computer HardwareReplies: 1Last Post: 03-01-2010, 10:43 PM